joeybronzoni

It took my some cycles to find this clip of the key latch seal kit: 2: Main Assembly

I realize I’m in the wrong build directions…. ooops

Version 2.3 does NOT have these square nuts since i do not see them and the printed part(orange for me) does not have any space for them either.

Version 2.3 number 7 pictured is replaced with “Parts Pack R” the “Rollerset” and the “washers” from number 7 are now in “Parts Pack F”

I am guessing version 2.3 does not come with these rollers like the one that comes with the prusa mini but instead comes with “Roller Set” from “Pack R”. And in that case you just use the Orange Roller Flange from “Pack F” as spacers on those rollers and that should do it. I’d pop a picture but my last comment got labeled as spammed but I’ll try again.

I’m thinking that for the version 2.3 that the washers are found in the “Parts Pack F” and I mean found with the 4 printed orange washers.

The rubber washer will fit if you flip the nut over as mentioned. I just want to point out that you can keep the rubber washer on if you flip the nut before threading it.

Yea that’s a tough one that I am thinking on myself now. I’ve seen something like this: https://freeimage.host/i/5GYgWX. Which if I were to use I would put the holes in the back of the RepBox. But I can’t convince myself to put the holes in the back for the sake of easy access. I’ll try and put them facing in the front and will return with an image of the final setup if I make it that far hah. Yea… I’m open to seeing other’s ideas on the MMU2S setup but I will gladly share mine once its done.

For version 2.3 I’m not seeing Parts Pack A: Roller Bearings- 24PCS in this Tube. But its not labeled on the tube to be in there either. I am assuming that maybe the “roller set” has replaced these? I’ll adjust this comment when I get to the end of the road here but for those that also do not see the “Parts Pack A: Roller Bearings- 24PCS” don’t panic…. yet. Haha.