Skip to main content
    • Insert wisdom here.

  1. Top hinge clamp plate
    • Top hinge clamp plate

    • 16mm bolts, M3 Nylocks

    • Top Panel

  2. Stand the top panel on end so the holes are at the top closest to you Press three 16mm bolts in the middle 3 holes so that the ends of the bolts protrude from the unfinished side of the panel as pictured. DO NOT do the outside two holes right now. They will be done in a later step.
    • Stand the top panel on end so the holes are at the top closest to you

    • Press three 16mm bolts in the middle 3 holes so that the ends of the bolts protrude from the unfinished side of the panel as pictured.

    • DO NOT do the outside two holes right now. They will be done in a later step.

    • Make sure you have removed the vinyl cutouts from the hinge prior to assembling as outlined in STEP 0

    • The hinge holes will only line up on one side so find the side with matching holes and press the vinyl hinge onto the exposed bolts. Do this while the panel is standing up so the bolts don't fall out on you. The vinyl will hold them in once pressed on so you may lay the panel flat again with the unfinished side up.

    • Place the clamp bar over top the exposed bolts so that its edge and the edge of the top panel line up evenly.

    • Time to move on to STAGE 4

Finish Line

3 other people completed this guide.

Pooch

Member since: 09/15/2018

2,505,387 Reputation

55 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 341