Skip to main content

Site Navigation

Your Account

Choose Language

  1. STANDARD KIT (Pic 1) MDF Side Panels
    • STANDARD KIT (Pic 1)

    • MDF Side Panels

    • 16mm bolts, Square Nuts, Magnetic Catches

    • SEAL KIT (Pic 2)

    • MDF Side Panels

    • 3D Printed Seal Bars

    • 16mm bolts, Square Nuts, (from fastener bag) Magnetic Catches

    • Later production seal kits come with a slightly modified fastener configuration that places them one above another as opposed to side by side. This is normal and only 16mm screws are needed.

  2. Lay your steel side panels over top the unfinished side of your MDF side panels and line up the holes Press 16mm bolts through from underneath the side panels and through the mounts of the magnetic catch. Magnetic catch should be facing the front of the side panel as pictured. You may adjust the final position of the catch later on in the assembly.
    • Lay your steel side panels over top the unfinished side of your MDF side panels and line up the holes

    • Press 16mm bolts through from underneath the side panels and through the mounts of the magnetic catch.

    • Magnetic catch should be facing the front of the side panel as pictured. You may adjust the final position of the catch later on in the assembly.

    • Place a square nut on top of the bolt with its flat edge against the magnetic catch and tighten bolts but leave loose enough so that the mag catch position can still be adjusted

    • Attach a universal bracket to the top of the side panel assembly just above the mag catch. The U Bracket should be bolted on through the middle hole so that the flat edge is facing the rear of the box using a 16mm bolt.

    • Repeat for both side panel sets

  3. Press square nuts into all square traps in each seal bar. Lay your steel side panels over top the unfinished side of your MDF side panels and line up the holes Attach the seal bar to the side panels with the 16mm bolts.
    • Press square nuts into all square traps in each seal bar.

    • Lay your steel side panels over top the unfinished side of your MDF side panels and line up the holes

    • Attach the seal bar to the side panels with the 16mm bolts.

    • Attach the mag catch to the top hole sets in the seal bar facing forward using 16mm bolts

    • Repeat for both sets of side panels

Finish Line

One other person completed this guide.

Pooch

Member since: 09/18/2018

593 Reputation

16 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 335