Skip to main content

Introduction

Using this method you will completely remove the old v6 hotend assembly and wires for the heater and thermistor from your Prusa MK3/S/+

THIS IS A WIKI! As such it is a living breathing document. If there are details or images that you feel would better help illustrate how to do something please post them here to help others. Thank you to all those who have contributed!

  1. Your kit included a pre-cut and chamfered piece of PTFE that you can immediately place into your Revo 6 and skip steps 9-15 (at the time of this writing) as mentioned in the official E3D guide.
    • Your kit included a pre-cut and chamfered piece of PTFE that you can immediately place into your Revo 6 and skip steps 9-15 (at the time of this writing) as mentioned in the official E3D guide.

    • Rather than reinvent the wheel at this point we are going to refer you to the official E3D MK3/S/+ developed by the amazing Will Hardy. ACCESS THE GUIDE HERE

    • PLEASE BE SURE TO READ AND FOLLOW THESE INSTRUCTIONS CAREFULLY! THERE ARE SMALL DETAILS THAT IF MISSED CAN IMPACT THE FUNCTION AND PERFORMANCE OF YOUR 3D PRINTER AND YOUR REVO HARDWARE!

    • Given how difficult and under-appreciated good technical writing is please take a moment to go to Will's Twitter here and leave him a note on how awesome you think his guide is.

    • Make absolute sure you go through the proper calibration steps for PID tuning and first layer calibration as outlined at the end of the E3D Guide here!

Finish Line

One other person completed this guide.

Pooch

Member since: 09/15/2018

2,505,393 Reputation

55 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 161