I didn’t get the seal kit, so I had to attach the two handle parts together by putting a square nut into the part that would turn the key and attaching the other part using a 3mm x 10 screw.
Oddly the 1st picture shows this having already been done.
Picture 2 doesn’t show the referenced nuts. In fact, it shows one screw thru the parts and the 2nd screw is completely hidden. A different photo might work better to clarify this.
Base Reinforcement Bar = 15
Base Cross members = 16, 17
Side Panel = 9,10
Center Track Guide = 3
I didn’t get the seal kit, so I had to attach the two handle parts together by putting a square nut into the part that would turn the key and attaching the other part using a 3mm x 10 screw.
Oddly the 1st picture shows this having already been done.
Picture 2 doesn’t show the referenced nuts. In fact, it shows one screw thru the parts and the 2nd screw is completely hidden. A different photo might work better to clarify this.
Top Panel = 14
Top Hinge Clamp = 6
Acrylic Lid = 23
Faceplate with the Engraving on it = 22
Rear Lid Seal Bars = 18 bottom lid seal; 19 top lid seal; 20,21 side lid seals.
Rear Panel = 1
The Rear Track Guide = 2,4,13
The Base Panel = 14
The Front Exit Panel = 12
The naming conventions are inconsistent with “Step 0 Getting Started”. It would be more helpful to describe the parts by their part number.
The Rear exit panel is 2,4,13
The base panel is 14